10-25-2007, 04:13 PM
1.) Insert a wire in the R- socket, and another wire in the R+ socket of the camera.
2.) Fuse the wires into their sockets.
2.) Connect the R- wire to the negative terminal, and the R+ wire to the positive terminal of the RS-485 interface.
3.) Open the GeoVision software, click on the Configure icon, and select System Configure in the drop down menu.
4.) Once inside System Configure, checkmark PTZ Device Setup under PTZ Control.
5.) Select the drop-down menu under PTZ Control, and choose Pelco Dome.
6.) Under PTZ Control, click the socket icon, select Protocol P, checkmark Activate, and press OK.
7.) Click OK to exit out of the System Configure menu.
8.) Click on the PTZ icon to activate the PTZ control menu.
9.) Once the PTZ control menu is activated, select Address 0 in the drop down menu.
10.) Click on the Plus icon (+) to zoom in, and the Negative icon (-) to zoom out.
2.) Fuse the wires into their sockets.
2.) Connect the R- wire to the negative terminal, and the R+ wire to the positive terminal of the RS-485 interface.
3.) Open the GeoVision software, click on the Configure icon, and select System Configure in the drop down menu.
4.) Once inside System Configure, checkmark PTZ Device Setup under PTZ Control.
5.) Select the drop-down menu under PTZ Control, and choose Pelco Dome.
6.) Under PTZ Control, click the socket icon, select Protocol P, checkmark Activate, and press OK.
7.) Click OK to exit out of the System Configure menu.
8.) Click on the PTZ icon to activate the PTZ control menu.
9.) Once the PTZ control menu is activated, select Address 0 in the drop down menu.
10.) Click on the Plus icon (+) to zoom in, and the Negative icon (-) to zoom out.