10-26-2007, 11:45 AM
Yes, so actually we have a special instruction for the Kalatel dome as below:
The picture below is Kalatel CyberDome converter to camera connections, because of all dip switch were off, therefore please adjust the baud rate to 9600 in GV-Main system control panel.
If you're using the Kalatel dome, you can use the above method to make it work.
P.S. GE's dome is not included in our supported PTZ dome list.
Pelco PTZ has 4 connectors: RS PLUS, RS PLUS, PX PLUS, PX MINUS
Try to connect 422's RS+ on the PTZ to 485+ on the NET, and RS - to 485 -. It probably will work.
The picture below is Kalatel CyberDome converter to camera connections, because of all dip switch were off, therefore please adjust the baud rate to 9600 in GV-Main system control panel.
If you're using the Kalatel dome, you can use the above method to make it work.
P.S. GE's dome is not included in our supported PTZ dome list.
Pelco PTZ has 4 connectors: RS PLUS, RS PLUS, PX PLUS, PX MINUS
Try to connect 422's RS+ on the PTZ to 485+ on the NET, and RS - to 485 -. It probably will work.