10-26-2007, 11:54 AM
Only version 8.1 software allows ptz to work on auto tour.
When the PTZ remains stationary for a certain time, the camera can automatically activate the auto mode, move to the designated preset point or start the preset tour.
1. On the main screen, click the Configure button, and select Camera Mapping PTZ Dome. This dialog box appears.
2. Select the desired camera from the Device drop-down list, and check PTZ Inactivity.
3. Set the idle time after which to start the protection mode.
4. Select Auto, Preset or Multi Position Tour as protection mode.
Setting Multi Position Tour
You can create a PTZ tour with up to 16 preset points
1. Select Multi Position Tour on the Camera Mapping Setup dialog box (see Figure 1-25), and click the Setting button. This dialog box appears.
2. Select a Preset as a start point.
3. Set the Dwell Time that the PTZ will remain in a preset.
4. Click Add and repeat Steps 2-3 to build more points in the tour.
When the PTZ remains stationary for a certain time, the camera can automatically activate the auto mode, move to the designated preset point or start the preset tour.
1. On the main screen, click the Configure button, and select Camera Mapping PTZ Dome. This dialog box appears.
2. Select the desired camera from the Device drop-down list, and check PTZ Inactivity.
3. Set the idle time after which to start the protection mode.
4. Select Auto, Preset or Multi Position Tour as protection mode.
Setting Multi Position Tour
You can create a PTZ tour with up to 16 preset points
1. Select Multi Position Tour on the Camera Mapping Setup dialog box (see Figure 1-25), and click the Setting button. This dialog box appears.
2. Select a Preset as a start point.
3. Set the Dwell Time that the PTZ will remain in a preset.
4. Click Add and repeat Steps 2-3 to build more points in the tour.