01-14-2008, 12:28 PM
1.) Open the camera housing
2.) Connect a video cable to the camera using a BNC connector
3.) Connect a 24V power supply to the L+ and N- terminals, which are located in a six pin block inside the camera housing
4.) Attach the adhesive side of the rubber square to the bottom of the camera housing where there is a circular hole
5.) Screw the plastic bolt into the circular opening located at the bottom of the camera housing
6.) Find the side of the rectangular mount that has two cut circles on each end, and place one of the circular ends over the plastic bolt
7.) Screw in the rectangualr mount to the camera housing
8.) Repeat the above steps for the remaining camera
9.) Screw the L-shaped mount to the bottom of the rectanguar mount
10.) Scew the L-shaped mount to a wall
2.) Connect a video cable to the camera using a BNC connector
3.) Connect a 24V power supply to the L+ and N- terminals, which are located in a six pin block inside the camera housing
4.) Attach the adhesive side of the rubber square to the bottom of the camera housing where there is a circular hole
5.) Screw the plastic bolt into the circular opening located at the bottom of the camera housing
6.) Find the side of the rectangular mount that has two cut circles on each end, and place one of the circular ends over the plastic bolt
7.) Screw in the rectangualr mount to the camera housing
8.) Repeat the above steps for the remaining camera
9.) Screw the L-shaped mount to the bottom of the rectanguar mount
10.) Scew the L-shaped mount to a wall