05-07-2008, 12:49 PM
Setup Your Receiver and Transmitter:
#1. Install the included software onto your computer.
#2. Connect the Ethernet cable between the S200/S600 Transmitter and your computer.
#3. It would take around 1~2 minutes for the connection.
#4. After Windows says connected, please run the program installed in step #1, and then click “Connect”.
#5. The dialog box would show “Wait for connection”, and then “Connected”.
#6. Change the default ID (Derytech) to your own ID.
#7. Click “Write Configuration” and close the program.
#8. Unplug the Ethernet cable from the Transmitter and plug it to the Receiver.
#9. Follow from step #3 to step #7 to set the same ID in the Receiver.
#10. Unplug the Ethernet cable from the Receiver.
p.s.1: The ID must be the same in your Transmitter and Receiver so that they could connect to each other.
p.s.2: The baud rate and other settings in the program are based on the camera model you have. Please contact your camera provider to get the correct settings.
Install your Receiver and Transmitter:
#1. Plug the dongle to your Transmitter, and then connect Camera and the Transmitter with the video cable.
#2. Plug the other dongle to your Receiver, and then connect TV/Output Monitor and the Receiver with the video cable.
#3. Plug the power cables into the Transmitter and Receiver and turn on your camera and TV/Output Monitor (make sure you select the correct input, i.e. Video1, Video 2).
#4. On your TV/Output Monitor, you should be able see the image transmitted from the camera wirelessly.
p.s.3: If you cannot see the image from the camera on your TV/Output Monitor, please unplug the power cables of the Receiver and Transmitter and plug them back.
#1. Install the included software onto your computer.
#2. Connect the Ethernet cable between the S200/S600 Transmitter and your computer.
#3. It would take around 1~2 minutes for the connection.
#4. After Windows says connected, please run the program installed in step #1, and then click “Connect”.
#5. The dialog box would show “Wait for connection”, and then “Connected”.
#6. Change the default ID (Derytech) to your own ID.
#7. Click “Write Configuration” and close the program.
#8. Unplug the Ethernet cable from the Transmitter and plug it to the Receiver.
#9. Follow from step #3 to step #7 to set the same ID in the Receiver.
#10. Unplug the Ethernet cable from the Receiver.
p.s.1: The ID must be the same in your Transmitter and Receiver so that they could connect to each other.
p.s.2: The baud rate and other settings in the program are based on the camera model you have. Please contact your camera provider to get the correct settings.
Install your Receiver and Transmitter:
#1. Plug the dongle to your Transmitter, and then connect Camera and the Transmitter with the video cable.
#2. Plug the other dongle to your Receiver, and then connect TV/Output Monitor and the Receiver with the video cable.
#3. Plug the power cables into the Transmitter and Receiver and turn on your camera and TV/Output Monitor (make sure you select the correct input, i.e. Video1, Video 2).
#4. On your TV/Output Monitor, you should be able see the image transmitted from the camera wirelessly.
p.s.3: If you cannot see the image from the camera on your TV/Output Monitor, please unplug the power cables of the Receiver and Transmitter and plug them back.