DVR Security Forum

How can I get to adjust the image of a D12 180 to seeming-less fit with each other.... The manual shows controls that are unavailable in the camera.

To display the 180º View Configuration, in the camera web browser interface, Go to >Setup >General Image Settings Camera Selection pull down and select 180º View, and make sure to check the tick box for Configuration Mode. Then Set and Close.

Thank you for getting back with me. WHen i go to Setup Menu > General Image Settings > the camera selection only gives me auto, left, right or both. Also, I see no tick box for configuration mode.


Any thoughts?

The only thing that comes to mind is that you possibly have a D12 and not a D12 - 180º. Please send me the factory IP address of the camera and I can check the database to figure out exactly what you have. Also, What software version is on the camera?

The factory IP is 10.4.29.244 and the release is 2.6.9.... if this camera is not a 180... what can I do to make it a 180?

The camera is a MX-D12Di-SEC. This means that the camera is not an 180º model and this functionality is not available in this camera. And, sorry to say, there is no way to change this camera to a 180º model.