05-01-2009, 09:05 AM
After you install the GV NVR and have Geovision software open:
Click the Configure button, select General Setting, select Camera / Audio Install and click IP Camera Install. The dialog box appears.
Check Install IP Camera box, select the number of IP cameras you want to link to, and click Configure button. The dialog box appears.
To automatically set up an IP camera, click Scan Camera to detect any IP cameras on the same LAN. Note that the Scan Camera function only works for GeoVision IP products.
To manually set up an IP camera, click Add Camera. The following steps are the example of manual setup.
Click Add Camera. The dialog box appears.
Type the IP address, username and password of the IP camera. Modify the default HTTP port if necessary.
Select a camera from the Brand drop-down list. The dialog box appears. The options in the dialog box may vary depending on camera brands.
Port: Video streaming port number.
Stream number: You may have the option of single or dual streaming.
Codec Type: You may have the codec option of MPEG4 or JPEG. If the selected camera supports dual streaming, the preview codec and recording codec can be set differently.
Resolution: You may select the different resolutions for preview and recording.
Click Apply. The IP camera is added to the list.
Click the listed camera, and select Display position to map the IP camera to a channel on the GV-System.
The Status column now should display "Connected". Click OK.
Click the Configure button, select General Setting, select Camera / Audio Install and click IP Camera Install. The dialog box appears.
Check Install IP Camera box, select the number of IP cameras you want to link to, and click Configure button. The dialog box appears.
To automatically set up an IP camera, click Scan Camera to detect any IP cameras on the same LAN. Note that the Scan Camera function only works for GeoVision IP products.
To manually set up an IP camera, click Add Camera. The following steps are the example of manual setup.
Click Add Camera. The dialog box appears.
Type the IP address, username and password of the IP camera. Modify the default HTTP port if necessary.
Select a camera from the Brand drop-down list. The dialog box appears. The options in the dialog box may vary depending on camera brands.
Port: Video streaming port number.
Stream number: You may have the option of single or dual streaming.
Codec Type: You may have the codec option of MPEG4 or JPEG. If the selected camera supports dual streaming, the preview codec and recording codec can be set differently.
Resolution: You may select the different resolutions for preview and recording.
Click Apply. The IP camera is added to the list.
Click the listed camera, and select Display position to map the IP camera to a channel on the GV-System.
The Status column now should display "Connected". Click OK.